Finally my reefer is here now to design the hard plumbing for a spray bar and into th

[Drewy1988]

Note if you buy a echotech vectora m1 it dose not take soft tube plumbing you will have to hard plumb it.

With the bubble magus curve 7 it doesn't leave much room for a in sump reactor so I have to make a spray bar for the two out of sump reactors I want..


Sent from my iPhone using Tapatalk

 

[mcgyvr]

I believe the term you are looking for is "return manifold" not spray bar.. A spray bar is a type of manifold in essence but a manifold is not really a spray bar.. A spray bar is located at the output of the return pipe in an effort to spread flow out over multiple ports vs a single return output tube..

A manifold has "T" connections and valves to allow you to T off some of the return pump flow to feed reactors or other areas besides just returning the water right to the display..

Very nice looking tank/setup though.. I'm sure you will enjoy it..
Looks great..