how to prevent flood?

M

motojoe1988

Member
So I have tank being made should be here tomarrow or monday.anyways my question is I had 4 returns built into the back glass 2 couple inchs from the top and 2 about 9" from the bottom. Now for a emergency or power down I know all the water should siphon back into the sump. Now how do I prevent this from happening being the returns are so low that a siphon break hole wont work correct? And everyone says not to relie on check valves. What else could I use? All returns will be running through a manifold so ill have ball valves for each return so I can manually control it but how do I prevent the piwer down fail safe? Thanks
 
Not to knock the design, but that sounds like a closed loop system. With the 2 being on the bottom, you are almost 100% sure to flood your house on the first power outage. What you could do is instead of the first elbow put a T piece of pVC there. One side will run straight up and the other will run down to the sump. I am not sure if this will make loud gargle sounds, but it will break the siphon in a power outage. Hopefully you get a mental picture from my description.
 
You need a big sump or an over flow in the sump that would prevent the sump overfilling unto the floor. That 9 inch from the bottom will be the real problem.
Are the holes at the bottom that necessary. You can just cap them. Any kind of checkvalve failure will leave you 9 inches of water in the aquarium. Best to have a backup to your checkvalve. Things go wrong sometimes despite our good efforts.

Another option make the two lower holes a closed loop , you need another pump though
 
Last edited:
Yes its similar to closed loop. But its not ha. I think I know what your saying about teeing off. But as u said im not sure about the sound or if it actually will work.think I may have too stick with a check val
 
Continued, almost like a dorso pipe after you place the T on you cut another piece of PVC maybe 5" and place a cap over it. Drill a hole in the middle of the cap, to allow air to go in a break the siphon. Since water flows down, you don't have to worry about water flowing out the hole.
 
Sry, I just re-read the post and was thinking 2 exit and 2 returns. So in your case check valves are good. Lol also invest in a good battery back up for the return pump.
 
Yea . I may end up doing a check valve on each bottom return and one on the. Manifold right where the pump connects to the manifold so ill have 3 check valves for back up.? That sound prepared? I would lime to have battery back up but $ tight right now. How much are back ups?
 
Been there done that. If you rely on check valves to prevent flooding, you WILL have a flood. Maybe not a month or a year but it's not if you will have a flood, it's when. At least if you stay in this hobby. I've come home to find my house flooded and 500 gallons of water running out of my garage by way of the laundy room and down the driveway.

It's real easy to add an overflow. Keep your close look and closed loop. Have your sump feed itself from an overflow or at least or at the very least a point high enough that the siphon will break before your sump is overflowing. Same goes for the return. Have it high enough that your sump won't overflow before the siphon breaks.

Avoid check valves at all costs. Especially if you are in the middle of a new build, it's just doesn't make sense not to have to rely on them. Do it right the first time.

A redigned by plumbing and sump a numbers years back and eliminated all check valves and it was one of the best things I ever done. I haven't had a flood in years and I had more than a few before that.

Being in the computer business, I can tell you that while UPS's are great, the batteries seem to fail after about year and I don't use cheap UPS's either. Also, depending on the size of your pump, the amount of up time without AC power may be less than you think. I wouldn't want to rely on a UPS to keep my home from flooding if the power went out.

My $.02!
 
You're using a Herbie or BeanAnimal type overflow drain, right?

The only way to prevent a flood with those holes near the bottom is to have a sump big enough to hold all the water.

I'd strongly recommended against plumbing your system that way. If you want holes near the bottom, use a closed loop. Plug them otherwise.

IMHO, not having enough extra room in the sump to cover a worst case scenario (preferably with headroom) is begging for a flood. My sump will take all the tank water that might drain AND the entire ATO reservoir.

If you can't plug those holes, I'd contemplate getting a new tank. I can guarantee you it will cost FAR less than the flood.
 
3/4" is pretty small, what pump are you using?

I'd seriously consider going closed loop for the lower drains. IMHO having those lower drains going into the sump is a very bad idea.
 
The manifold will b 1". Im not changing the set up to closed loop because it will be an all bta anemone tank. Hints the 4 returns. No powerheads. I will be trying the rio 32h hyperflow.
 
In that case, I'd recommend getting a sump big enough to hold all of the water that could drain. If need be, hook a big stock tank or something up to the sump.
 
I have a 40 gallon sump but I think ill have to just have check valves. Was wondering if theres another soloution other then closed loop.
 
motojoe1988 said:
I have a 40 gallon sump but I think ill have to just have check valves. Was wondering if theres another soloution other then closed loop.
Click to expand...

nope, not unless you can figure out a way to stop gravity. And i 100 percent agree if you rely on check valves you WILL have a flood eventually. Be it 1 or 2 or even 3 they always fail.

You could cap the bottom two holes and just use the top 2. This would be the safest and easiest solution to your problem. I have over 100 check valves at my store on systems and in a power outage you can hear many failing to do there job lol. Please do not rely on check valves
 
You must log in or register to reply here.

Similar threads

S
Small Sump Leak - Worth fixing?
Replies
1
Views
155
griss
griss
C
Can’t keep overflow box balanced
Replies
2
Views
181
Cruzersmith
C
S
Novice Aquarist - Sump & Equipment Questions
Replies
9
Views
375
wvned
wvned
T
I'm confused...
Replies
12
Views
632
wvned
wvned
A
Dual overflows 2 full siphon, 1 emergency, 1 return
Replies
1
Views
481
Vinny Kreyling
Vinny Kreyling
Back
Top