Korallin C-1502 has metric fittings doesn't it?

[tkeracer619]

Getting ready to setup a Masteflex fed Korallin C-1502 with a dual stage reg and want to switch over to john guest style push fit connectors. Before I go out and buy a bunch of fittings... it's metric isn't it? If that's the case what about the airline tubing used on it... what can I replace that with to have a reliable/leak free fitting? The stuff it came with isn't close to being long enough.

It's going on a tank that sits in my living room on hardwood floors.

Thanks all :wave:

 

[ElCamino]

Yes its metric, the outer diameter of the green tubing is smaller than standard 1/4 inch ice maker line. i just held a piece of ice maker line up to my CA reactor is how i come to this conclusion.

 

[GoVols]

I see they sell as their BioDenitrator too.

Anybody used it for nitrates?

If so what's been the pro's and cons with it.

 

[tkeracer619]

I ended up using the stock fittings with short pieces of the factory tubing (the stock fittings are secure with the metric tubing)then used a straight barb to connect tubing from home depot to make the long runs. I'll replace it all once I get new metric tubing or new metric fittings.

What sucks about this is if you were to break a fitting you would be out of luck until you could get a replacement.