New 6000 froze up

[Philwd]

Hi Roger,
Just got my 2 6000 Streams and 7500 from Kingsley here in Phx last week. Got them all set up over the weekend. They created quite a storm of detritus( no sand storm however). I really needed the extra flow. However after about 2 hours one of the Steams driver started giving off an alarm and the Stream stopped. Reading the manual I assume something got clogged. Where should I look first? I am brand new to Streams and want to make sure I get it right.
BTW the other Stream wasn't running during all this time as I needed to rethink where to place it for best flow.

Thanks,
Phil

 

[rvitko]

The most likely cause is either the bush bearing was loose from shipping and jammed on the brakes or their is detritus inside the pump causing it to lock up. Just follow the procedures in the manual for removing the drive unit and check the bush bearing (collar around the top)