New crispa or malu

top shelf

New member
My new nem finally arrived today. I dug a hole in the sand, placed it in, then buried its foot a little bit. I turned down the LEDs to about halfway for now while it adjusts. I also turned off all flow to allow it time to attach. After maybe an hr or so I'll turn the return pump back on followed by one vortech at a time. Also placed the foam guards on my vortechs.

Its mouth was pretty open upon arrival but within minutes of being in the tank it started to tighten back up. It's fairly bleached but that was to be expected. I can see some faint purple on some of the tips though.

Photos were taken after 5min or so.
1c8e84d6afffacb9f8c2fccb6c616b61.jpg
f4114b3897d1bdfde2524ee836640ed0.jpg
3cf5b5babfcc5a6f40ed04821fda9ede.jpg


Sent from my SM-G965U using Tapatalk
 
Congrats, it looks good. I would have put it in the QT for observation for a few days though.

Sent from my BLN-L24 using Tapatalk
 
I usually do either qt or dip everything new but in this case I did not. I hope the gamble doesnt come back to bite me. It's been an hr and a half and it's still yet to plant its foot. Came home from getting my boy at school to find it flipped over in the sand. I did turn the return back back on for some flow but vortechs are still off.
 
Definitely not crispa.
Malu often have rings on tents, being bleached it's hard for me to say for sure, but I actually think it might be aurora
 
Aurora has more prominent beads no?

Sent from my BLN-L24 using Tapatalk

I thought so as well. All the Aurora I have seen have always been drab brown where as this one has some purple in its tents. Once it colors up I'm sure a more positive ID can be made.

I dug a deeper hole and buried the foot more and so far it has stayed planted the last few hrs. Both vortechs are running at reduced power.
 
I could be wrong, I'm not super familiar w/ aurora, it just looks more beaded than rings to me in those pics
 
I could be wrong, I'm not super familiar w/ aurora, it just looks more beaded than rings to me in those pics

I think you might be right, if that turns out to be the case I think I'll be swapping at the lfs and see if I cant have them order me a mag.
 
Appears to have finally settled in and hasn't moved. Vortechs are back on normal speed and slowly turning lights back up.
1aea8820678d783c48e8c49cc9365c10.jpg


Sent from my SM-G965U using Tapatalk
 
Day 5 and still in the same spot. Mouth hasn't tightened up all the way yet but otherwise looks healthy so I'm not to worried.
1eac0e209795763fc9c71f635f72da1d.jpg


Sent from my SM-G965U using Tapatalk
 
Back
Top