sahin
Ultimate Reefer
I have a 28G Nanocube, with the following equipment:
150w MH – Phoenix 14K bulb
16x Cree Royal Blue LED’s @ 700mA
Tunze Osmolator Auto top off
Vortech MP10
Parameters are:
Alk: 7.5dKH, CA: 390ppm, pH: 7.9-8.2, Mg: unknown but I do 20% water changes weekly so don’t test for it, Temp:79-80, nitrates: 0ppm (used to be 25ppm) and phophates: 0ppm (used to be 0.5ppm, now use GFO)
I dose C-Balance and Kalk (later via Osmolator).
I have one Acro nana which now has deep purple tips as well as three differant green coloured SPS (dont know names).
Other than these, the others (about 10 other frags) dont have good colours and are either brown or very dull.
Is it possible that as frags, corals wont exhibit thier best colours? I read somewhere that once frags mature into colonies thier colours are better. Not sure how true this is.
The oldest frag is from mid Feb, others are a little newer.
Am I being too impatient and should I wait say 6 months more to see how things proceed?
Any ideas/tips/suggestions on how I can improve my coral colours or rather improve some aspect of my setup to get better colours?
Many thanks.
150w MH – Phoenix 14K bulb
16x Cree Royal Blue LED’s @ 700mA
Tunze Osmolator Auto top off
Vortech MP10
Parameters are:
Alk: 7.5dKH, CA: 390ppm, pH: 7.9-8.2, Mg: unknown but I do 20% water changes weekly so don’t test for it, Temp:79-80, nitrates: 0ppm (used to be 25ppm) and phophates: 0ppm (used to be 0.5ppm, now use GFO)
I dose C-Balance and Kalk (later via Osmolator).
I have one Acro nana which now has deep purple tips as well as three differant green coloured SPS (dont know names).
Other than these, the others (about 10 other frags) dont have good colours and are either brown or very dull.
Is it possible that as frags, corals wont exhibit thier best colours? I read somewhere that once frags mature into colonies thier colours are better. Not sure how true this is.
The oldest frag is from mid Feb, others are a little newer.
Am I being too impatient and should I wait say 6 months more to see how things proceed?
Any ideas/tips/suggestions on how I can improve my coral colours or rather improve some aspect of my setup to get better colours?
Many thanks.