VDM Port 2 14.6V???

bvoss

New member
I have my VDM controlling my AIs nicely and I have even hung some other LEDs on it using ports 1 and 4. They work fine, but Port 2 is putting out 14.6V and not responding to ramps or even turning off.

Am I doing something wrong, or is this another case where the VDM has to go back to Curt?
 

timry2

New member
Its your Controller

Its your Controller

Im having the same problem. Ive read that the only fix is sending the unit in for repair. My problem is everything on my tank is controlled by the Apex. dont want to take it down.

Are you getting 14v on all four or just V1 and V2
Thanks
 

bvoss

New member
I thought I would have to send mine in. I was certain I had the pin-out right. Then Curt informed me one of the other pins on the RJ45 will put out 14v. I ordered a Neptune RJ45 cable to be sure. I installed it this morning and everything is perfect. Oops.
 
Top