Well This is Fun…Not!

griss

RC Mod
Staff member
RC Mod
In preparation for finally setting up my dosing pump, I did my weekly water change today. Let the tank settle for several hours and tested Alk, Ca, Mg, NO3 and PO4. The first three needed some adjusting (then wait 5 days, test again to determine your daily need).

Well, from when I tested until when I dosed, I misread my own handwriting to the soda ash. I was SUPPOSED to dose 22.5 mL, I dosed 225 ml😳

pH skyrocketed according to my Apex. Currently using vinegar (the only thing I had) to try to bring it down.

Rics and Gorgs are not happy. Everything else looks okay so far.
 

Attachments

  • IMG_5431.png
    IMG_5431.png
    116.3 KB · Views: 18
Yep, not paying close enough attention. The little “.” makes a big difference. Sharing here so, hopefully, someone will learn from my mistake.
 
Well, I’ve been 8.27 - 8.29 for an hour now. Rics and Gorgs still not happy.
 
Agreed you may have dodged a bullet and caught it quickly. My ph regularly runs high, at least according to apex but it’s been that way for months so my SPS are probably used to it

IMG_0541.png
 
I have had my pH between 8.2- 8.4 as a daily swing for long periods of time.
I don't know that I would change anything else right now.
 
Most salt mixes run high on the alk, what salt are you using?
Plain boring old IO.

I used Coralife for many, many years until I ran into two different buckets in a row (different lot #’s) that had extremely low Alk and sky high Ca.
 
Back
Top