6025 shaf pulled from motor block

[UWUALineman]

I have a 6025 that started making some noise, and turns out, the stainless metal shaft has pulled from the motor block. Also, the white spacer on the rear of the impeller assembly has broken from the rest of the assembly. I tried to seat the shaft back into the black with a small hammer, however, it will not stay in place. What are my options? Can I just glue the white washer back into place?

 

[Aquadepot]

This is a warranty issue you will need to contact Roger at Tunze USA for repair.

Graeme

 

[rvitko]

How old is this pump? We haven't used the white disk since Jan 2008? It needs a new motor to be properly repaired. The shaft cannot be reinstalled reliably unless it is snug enough to press back in.

 

[UWUALineman]

I believe its around 3 1/2 to 4 years old. Used off and on in frag tanks etc. It makes a god awful racket.

 

[UWUALineman]

Not sure how long your warranty lasts, will I need to buy another motor block?

 

[Aquadepot]

Tunze pumps come with 2 year warranty, this may have been one of the early release that had some problems.

Send Roger an email or PM to discuss your options.

Graeme