6105 to Apex Connection

[crs751]

I'm looking into ditching my Jebao pumps for Tunze. In order to connect the Tunze to the Apex do I only need the power supply and the Apex cable or does the Tunze need the Tunze controller to interface between the Tunze pump and the Apex VSP's? Thanks.

 

[rvitko]

If you get a controllable model Tunze pump, it will include a controller and power supply. You then only need the Apex cable to hook it up, you will set the small built in controller to external mode to bypass it.

 

[crs751]

Thanks for the reply Roger. I was looking at used pumps. From what I see there is a plug module that accepts the power supply plug; the other end plugs into line current. The DIN cable connection then ties to the small controller you reference. However, if I plug in the DIN connection from the Apex cable do I still need the small Tunze controller?

 

[rvitko]

No, if you get the older version without controller it is just connected directly to the DIN port.

 

[crs751]

Thanks. The seller says the pumps were purchased in 2013 so to confirm I wouldn't need the Tunze controller. Just tie into the Apex correct?


Sent from my iPhone using Tapatalk

 

[rvitko]

Yes.