Yes, if you send it in, I will solder in a new moonlight, however I am out of replacements for a couple weeks so please wait to send it until I have the part.
Please wait to send it, I would prefer to keep it as short as possible and right now I have no photocell/ LED assemblies. If you remind me next week I should at least have an ETA or a tracking number.
Hi Roger -
My 7095's moonlight/sensor has also failed.
I am quite comfortable with soldering, so don't mind doing the job DIY.
Can I just order the 7094.050 and cut the pigtail off? Are the wires within the replacement color coded the same as the original without the pigtail?
The 7094.050 will not work, it is a photocell only with no moonlight. I would open the controller first and double check that you are comfortable with the work involved as the wires are quite small and you need a fine point tip. Additionally, controllers made in the last year have a quick connector so no soldering is required.
You don't need the controller to keep the pumps running and the down time would be very minimal, From VA to TX would take 3-4 days, 1-2 days for the repair and 3-4 days back. Including a weekend in the middle, it shouldn't take more than 2 weeks total.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.