der_wille_zur_macht
Team RC
Sorry Keith, didn't mean to hijack. The tank in the pic is described in this thread:
http://fingerlakesreef.com/forum/viewtopic.php?f=13&t=3343
http://fingerlakesreef.com/forum/viewtopic.php?f=13&t=3343
Here's a 1,400g plywood tank propped up to pour corner fillets:
Courtesy of user dnash on the fingerlakesreef forums.
why can't i see any of the pics thats posted up here?
The pictures are all hosted on www.box.net
Your browser or your firewall is mistakenly blocking things from that site.
Just try going to that site and see if you make it. If you don't - figure out why.
Instead of putting it on edge why not get some thin strips of acrylic & tape them into the corners, creating a triangle in each corner. The fill the hole with WO.
Did that make sense at all?
I don't understand how mere mortals are supposed to pull out a 320lb plastic box, (that has had seam delaminations while being handled with kid gloves), and balance it on those same seams while screwing with two part mixed chemicals.. I might as well walk to the moon right after DIY heart surgery on myself. :hmm4:
Thanks for the capillary point. :beer:
Why the concern for crazing here? None of the inside of the tank has ever been flame polished.. Just old acrylic shenanigans?
Not to change the subject too much but is your CL pump a 56j or c? I saw on the website you posted for mdm that they had adapters and was curious if that's what you did.
The only acrylic triangular stock ( that I know of) is an extruded, low molwcular weight material. It does not glue up as pretty as joining all cell-cast materials ( which is what tanks are made with)
Hey, sometimes you gotta go for the gusto.
Sandwich it between two sheets of plywood?