Hi everybody, I've gone as long a scan without asking for help but I think I'm in a pickle and need some help. I just got my Apex, connected to wifi, outlets doing what they are supposed to do. My problem is that when I try to use the dimming outlets on the base the LED's flicker. If I leave the Cat5 unhooked to where the LED's run at full there is no flicker. I'm sure it's something simple but I have no idea.
Here is one of my VAR outlets:
Set OFF
If Time 09:00 to 10:00 Then 455UP
If Time 10:00 to 19:00 Then 455ON
If Time 19:00 to 20:00 Then 455DOWN
Profile:
455UP
Ramp 60
SI 0
EI 100
455ON
Ramp 0
SI 100
EI 100
455DOWN
Ramp 60
SI 100
EI 0
These are the same settings for 3 other Drivers/Outlets/Profiles
If somebody could help me out that would be swell.
Thank you,
Tony
Here is one of my VAR outlets:
Set OFF
If Time 09:00 to 10:00 Then 455UP
If Time 10:00 to 19:00 Then 455ON
If Time 19:00 to 20:00 Then 455DOWN
Profile:
455UP
Ramp 60
SI 0
EI 100
455ON
Ramp 0
SI 100
EI 100
455DOWN
Ramp 60
SI 100
EI 0
These are the same settings for 3 other Drivers/Outlets/Profiles
If somebody could help me out that would be swell.
Thank you,
Tony