My wood tank build

[dsandfort]

Me too Mr. B. Come see it.

MarkS. Where were you when I needed you. Actually, I took out the stops after the silicone set up. It was a pain, but I had the same concern as you.

Well, it's all framed up. FRP goes on tomorrow. Should be able to set the tank in a couple of weeks. The opening is 8'1" wide and 22" taller than the tank. I plan to have removeable panels above the tank for front access. That work stuff is getting in the way again so don't look for many updates in the near future.

 

[virginiadiver69]

<a href=showthread.php?s=&postid=9175585#post9175585 target=_blank>Originally posted</a> by dsandfort
Luckily, I've build a couple of drift boats and they still float. Same deal here, only backwards.

Del

I said to myself after seeing the first few photos of the build, "this guy builds boats".
This is an inspiration to be sure.

 

[Misfit6669]

Hope to next time I'm in the area Del.

 

[erics3000]

Looks awsome>.Why did you use wood instead of drywall..

 

[EBOLII]

Is that a real tree or artificial? What is it called?

 

[Misfit6669]

<a href=showthread.php?s=&postid=10156824#post10156824 target=_blank>Originally posted</a> by erics3000
Looks awsome>.Why did you use wood instead of drywall..

I'm thinking cause drywall doesn't handle moisture very well at all. He might even seal the partial board too, that's if he hasn't already. The inside of the fishroom looks to be sealed but it could just be the lighting.

 

[cbui2]

great job Del, wood was used so FRP can be glue on so drywall hold moisture plus will create more problems later. FRP will go on without having to worried about anything and no need to prep, paint, sand& etc. since they already gloss white texture finish and saved tons of time. how high is the base from the floor and i guess you wont have anything below the tank correct. also are you going to make the tank sit below the ledge if you have one.

 

[dsandfort]

You guys are good guessers. Not accurate, but good.

I used OSB instead of drywall to protect myself from screwups. Let me explain. I've forgotten something important or needed to modify something I've built many times. This time, I used OSB screwed to the framing. Then, I used FRP rivets to install the FRP panels. OSB holds the rivets much better than drywall. It also holds screws better for future attachments. This way, I can take everything apart if I need to. No glue used except a little caulk at the joints. Plus, OSB has very good noise transmission loss properties.

Bart- the top of the stand is 36" tall. I did this so the top of the glass is exactly at my eye level and I still have room to get in the top of the tank. I plan to set the tank and see how it looks before I decide how to finish it off. My wife has a slate tile picked out for under the tank and I might put a nice cherry veneer on the tank frame to picture frame it.

I do plan on some sumps below the stand.

Oh, the tree/palm is fake. But it adds a nice touch to the marine theme, don't you think?

 

[cbui2]

almost got it right also what are your plans for lighting?

 

[dsandfort]

Going to start with 3, 400W MH in Luminarcs. I will probably supplement with some T-5s after consulting with GrimReefer. I'm really interested in the spotlight method used by folks in Japan, I think. Need to check that out more.

FRP on ceiling over tank is a done deal. Went really well.

 

[EBOLII]

what does frp mean?

 

[cbui2]

i knew that was fun holding FRP up, hehe.

 

[slandis3]

i know this is a stupid question, what is frp?

 

[dsandfort]

FRP=Fiberglass Reinforced Plastic. Waterproof, mildewproof, rustproof, foolproof (I hope).

Bart-I built some t-squares to help hold it up. Still, a full sheet is a real chore. Luckily, it's not too heavy, but so limp it's like holding up a sheet of pasta. I use some interesting language, according to my wife.

 

[EBOLII]

Still like to know about the tree too

 

[JCTewks]

<a href=showthread.php?s=&postid=10160821#post10160821 target=_blank>Originally posted</a> by dsandfort
Oh, the tree/palm is fake. But it adds a nice touch to the marine theme, don't you think?

 

[dsandfort]

I sure like FRP. Instant done. Thanks for the reminder/push/suggestion Bart. It's starting to look like a fish room. Whatcha think?

 

[cbui2]

look so clean and beautiful. no need for messy paint buckets and brushes. can wipe any spills in seconds, great job Del.

 

[viperdragon666]

sweet setup i wish i had my own house so i could have a tank like that

 

[TandN]

Man I wish I had the room I hate these threads makes me jealous lol