20H SPS Dream Tank

<a href=showthread.php?s=&postid=6719089#post6719089 target=_blank>Originally posted</a> by Travis Savant
Haha, with SPS, the addiction is ballanced by your wallet ;)

well then...um.. as u prob. know from n-r.com i um.. well, lets see.. um.. i guess my addiction will NEVER END!!!! lolololololol.....
 
New Coral...

Cali Tort, my personal all time favorite.
Cali-Tort.jpg


Green Slimmer, allittle blury, but it's realy a nice piece.
Green-Slimmer.jpg


Green Table, this one is an even brighter green than the Green Slimmer!
Green-Table.jpg


Orange/Red Digitata, small frag but they are realy fast growers.
Orange-Digitata.jpg


And last but certainly not least, the Silver Bullet, although I dodn't see anything silvery or bulletish about it...
Silver-Bullet-Maybe.jpg


I'll post a FTS when I have the Manifold up and working.
 
Ok, good news and bad news...

BAD NEWS
My Cali Tort began to STN, but I think I cought it in time and I fragged the uneffected parts. Here's a picture...
Fragged-Tort.jpg


More Bad News...
My A. Validia (Tri Color) has started to bleach. I think it is because it's dead center of the tank, and right under the MH, so I am going to cut my lighting back to a 6 hour photoperiod. From what I can tell, most people on RC run these lights for 6 HPD (Hours Per Day) any ways. Here is a before and after picture.
Before
Tri-Color-Acro.jpg


After
Bleaching-Validia.jpg


It still has polyps, so there's a chance it will make a recovery.

GOOD NEWS
I finaly got a good looking FTS...
FTS.jpg


Here's a side angle shot showing the manifold...
Angle-Shot.jpg


What do you guys and gals think?
 
travis your tank is looking good, its comming along really good, what fish you going to get for it??

Gabriel
 
Try to make a couple more flater surfaces for the sps.Rock looks good but you need less clutter.How is the heat issue with the 250w M.H? Thinkin of upgarding my 20gL lighting.Have you been adding calcium or are you thinking Nano C.reactor?
 
cuban, I think my rockwork is fine, and I will only be adding a few more piece of SPS (I'm thinking 3).

I am doseing Ocean's Blend 2 Part Ca and pH/Alk.
 
Travis,

I think that one of the reasons that the smaller tort piece STNed is due to the epoxy. With smaller frags, I've found that they tend to not do well when immediately mounted with a lot of epoxy, and seem to like being mounted first with superglue onto a small rock. After they heal a little, I do the superglue/epoxy sandwiching to get it onto the rockwork. I think that when they are small, the excess heat given off by the epoxy curing causes them to stress.

Tank is lookin good though! The monti caps should start plating pretty fast and will look awesome down there.
 
Back
Top