old 6055 shaft problem

[rainking]

hi,

i have an old tunze 6055, the spare part which holds the shaft to motor block is missing. i've made a diy circular bearing which fixes the shaft to motor block but after the pumps starts some time later that bearing moves from the bottom of the motor block so the pump fails to push water away.

my question is i have another 6055 whose cable is torn very near the motor block so can i make a one good 6055 motor from the two of them, l mean is it a way or spare part to fix the shaft to motor block fine..

thanx

 

[rvitko]

The shaft is pressed into a hole in the base of the pump, their is no bushing, just the molded plastic body of the pump. Out of the mold the hole is about half the diameter of the shaft so it is pressed in with a fair amount of force. In general the only repair for either condition is a new motor block 6055.100.