When building a tank this size, you put a bead of silicone down on the bottom panel, then you plac the side panel on top, with the size and weight of the side panel, what stops it from just pressing all the silicone out of the joint? or at least pressing enough out so the joint isnt strong?
This is an awesome sized tank. Would you mind going Into a little more detail about your refugiums, what is in them? How they are plumbed into the system? What the goal of them is? Anything else you can share
Each refugium is a little different.
the first one is right off my main drains and get plumb right back into my main drain.
the one is going to be high flow mangroves.
the second refugium is roughly 5 time turn over an hour.
its going to be mostly rock and sponges.
This one is plumbed into my main sumps center what house my reactors and more rock.
third refugium is going to be low flow with macroalgaes. what is plumb into my drains.
whole point is more filtration, more biodiversity, more food for all.
in the planning stage right now i might add a butterfly tank in my fish room.