Temp still will not calibrate via web (only tried via Firefox). Calibrated fine via display though.
and in regards to the storm - it works after you upgrade your VDM to sw revision 9.
After successfully updating the firmware, i get the following error when trying to update web pages:
Operation failed with the following error information:
Could not load file or assembly 'System.Core, Version=3.5.0.0, Culture=neutral, PublicKeyToken=b77a5c561934e089' or one of its dependencies. The system cannot find the file specified.
Anyone seen this?
It's possible that you're getting some sporadic interference causing the probe values to spike but by the time you look at the tank, the probe values have gone back to normal values. To test this, you could add a Defer statement to your email alarm, something short like 1 minute. That would smooth out any spikes.
Operation failed with the following error information:
Could not load file or assembly 'System.Core, Version=3.5.0.0, Culture=neutral, PublicKeyToken=b77a5c561934e089' or one of its dependencies. The system cannot find the file specified.
That error is most commonly caused by a missing or damaged installation of the Microsoft .Net Framework 3.5. I take it that you are probably running Windows XP or Vista. If so, download and install this: http://www.microsoft.com/download/en/details.aspx?id=25150. Then try the Apex web page upload again.firmware update goes through without issue, but when I try and update the webpages I get the following error: